cyberwhite foglamps

[sonoma1999]

I have these cyber white by navigator fog lamps, I was curious if I could wired them into my truck exisiting head lamps wiring? My truck didnt come with any fog lamps at all. Or do I have to wire them up separtly? I drive a 99 gmc sonoma ext cab 4.3L v6.

[Ron]

Not sure if this will help or not, but my neighbor wired some fog lights up to the headlights of his dodge van just by splicing into the headlight wires and then the fog lights turned on and off with the headlights. Not sure if this is the correct way to wire them up, but it seemed to work fine for him.

[nickr5208]

i ahve those exact lights...i just mounted their little switch it looks fine and the work great

[SmokinChevy2000]

fog lamps are pretty easy to install. usually most cars that have them factory installed have a separate switch to control them separately from the headlights. most aftermarket ones are like this too. I installed fog lamps (driving lamps actually, but whatever) myself, and i just used the included switch to control them. Pretty basic: connect wires to lamps, connect leads to (+) and (-) terminals, and wire up the switch in the circuit. Only thing is make sure u don't forget that they're on AFTER you're done driving otherwise if u don't have them wired up to the ignition (like i do) u will wind up with a dead battery. I learned this the hard way :-(

[sonoma1999]

now were did you mount the switch at? im thinking about mounting it were the current light knob is at. How did you run the wires into the cab?

[nickr5208]

my switch is horizontal, underneath my interior light switch on the panel of switches...just cut out a hole for it(better to start small, put a little super glue to the swith and your done

[SmokinChevy2000]

i put mine on the lower dash panel to the left near the door. just like nick-->started with a small hole then went bigger as needed.